Trustpilot

Arcadia T5 Reptile Twin Controller 54W

This product is covered by our Safe Delivery Guarantee

£40.99
€46.93
$58.00
$75.12
DKK349.52
NOK449.34
SEK478.41
$74.66
RRP £79.99 Save £39.00
RRP €91.57 Save €44.65
RRP $113.19 Save $55.19
RRP $146.60 Save $71.48
RRP DKK682.07 Save DKK332.55
RRP NOK876.87 Save NOK427.53
RRP SEK933.60 Save SEK455.19
RRP $145.69 Save $71.03
You save £39.00
You save €44.65
You save $55.19
You save $71.48
You save DKK332.55
You save NOK427.53
You save SEK455.19
You save $71.03

Arcadia T5 Reptile Twin Controller 54W

Product Code: LAS385

Arcadia T5 Reptile Twin Controller 54W
   

More product images

Arcadia T5 Reptile Twin Controller 54WArcadia T5 Reptile Twin Controller 54W

Printer Friendly

Download the Buying Guide

Download the Technical Guide

 
Description
Reviews
Delivery

FEATURING HIGH FREQUENCY ELECTRONIC BALLAST

  • Incorporates an electronic ballast designed for use with high output T5 lamps
  • Complete with Ultra Seal lampholders and Stainless Steel Clips
  • Long mains lead for easy mounting
  • Independent lamp circuits, if one lamp fails the other will continue to run
  • IP67 lamp holders can be used in vivariums with misting systems and in close proximity to water
  • IP67 controller housing can be mounted inside the vivarium if required
  • Mini plug and socket connector on lamp holder leads, allows the lamp holders to be detached from main unit

Fitting Tips

The Arcadia Reptile Ultraseal lamp holders offer both keeper and animal total security against dangerous water ingress. To comply with the new waterproof lighting regulations we have designed and made this system to be IP67 or waterproof. This does however mean that the lamp holders must be tight. To enable the safe and easy fitting of lamps the following advice is given:

  • Unscrew the lamp rings from the lamp holders.
  • Use a very small amount of Vaseline on the rubber seal on the inside of the sealing ring to moisturise the rubber seal. Wipe away and overspill from the lamp holder and lamp.
  • Slide the lamp ring over the lamp and carefully line up the pins on the lamp with the two holes inside of the lamp holder and push gently. The lamp should seat into the lamp holder with a slight click. Do not turn the lamp as the pins will sheer off.
  • Slide the lamp ring back down towards the lamp holder and holding the lamp tight with one hand screw up the lamp ring until gently seated with the other.
  • T5 lamp run hotter than T8 lamps and the rubber seal around the lamp sealing ring may stick to the lamp or degrade over time, these rings can be easily replaced with product code AB5R.