ProRep Bug Grub is a complete dry diet, high in calcium and protein, designed for the breeding and maintenance of all livefood insects.

It is made from the highest quality ingredients to ensure maximum palatability.

Directions: Place Bug Grub in a shallow dish and place in the feeder insects enclosure, ensuring that the insects can get to it. Only feed enough Bug Grub each time to last 1 or 2 day. Provide fresh food regularly as mould will grow if Bug Grub gets wet. Bug Gel and/or small pieces of Carrot should always be provided as a source of moisture.

Precautions: Not for human consumption. Wash hands after use. Do not inhale dust.

Contents: Protein 16%, Oil B 4.5%, Fibre 17.2%, Ash 11%, Moisture 13.8%, Magnesium 0.3%, Vitamin A 5000iu/kg, Vitamin D3 500iu/kg, Vitamin E 20iu/kg, Selenium 0.05mg/kg, Copper 30mg/kg.

Cork bark is a great natural looking addition to your vivarium. The flat pieces can be built up to make ledges or climbing places for your reptiles.

Hide made from natural wood that fits into any design of vivarium or terrarium.

Bug Balls are the ideal way to provide water to feeder insects without the risk of them drowning. They are available in 500g resealable packs in a variety of different colours. Simply place a suitable number of balls in a shallow container in the livefood holding tank to prolong the life of the insects and keep them healthy. Replace as needed and re-seal the pack to retain freshness.

ProRep Heat Mats and Heat Strips are designed for use with reptiles, amphibians and invertebrates. They work by producing ultra long wavelength infra red heat that is absorbed by the animal and cage furnishings in much the same way as the sun warms basking animals or the ground in the wild.

This action allows the animals to warm themselves without necessarily raising the air temperature in the vivarium or tank. The choice of heat mat size and installation method will depend very much on the requirements of the species and the design and size of the set up and supplementary heating may be required for species that require a more intense heat or localised basking spots to raise their body temperature sufficiently.

Care must be taken to comply with the safety and installation instructions and the use of a thermostat is essential. ProRep Heat Mats and Strips are available only in cloth heating element materials - and in a range of sizes to suit most heating requirements and are manufactured in the UK to the highest safety standards.

The High Out Put models are design to be fixed to the wall or ceiling of an enclosure through the use of the special adhesive which is applied to the heat mat. These heat mats produce a much higher temperature than standard heat mat models, they MUST be used with a thermostat and they MUST not be covered.

ProRep Live Moss can be used as cage decoration or as a substrate and is normally used wet to provide high humidity for moisture-loving reptiles, amphibians and invertebrates.

It is also suitable for use in a wet box for egg laying or shedding. Live Moss is harvested from sustainable sources.

Directions: Place the required amount in a container of clean de-chlorinated water for 10 minutes. Remove and squeeze gently to remove excess water.

Please note that this is a fresh, living product and is not sterile.

Solid, quality branches of wood. Java branches are sand blasted to guarantee cleanliness and smoothness. Great shapes for all animals to climb, bask and explore.

Each piece is unique so shape and size may vary from picture.

Heater Guards for spot lamps or small ceramic heaters to protect animals from burning themselves. Simple, lightweight but strong powder coated steel design that allows maximum light penetration. Unique hinged panel with double security fasteners that allows easy access to lamps without the need to remove the fixture. These guards have four mounting brackets and cut-out for cable entry to enable flush mounting to the roof of wooden vivaria.

L 12cm W 12cm H 22.5cm

ProRep Heat Mats and Heat Strips are designed for use with reptiles, amphibians and invertebrates. They work by producing ultra long wavelength infra red heat that is absorbed by the animal and cage furnishings in much the same way as the sun warms basking animals or the ground in the wild. This action allows the animals to warm themselves without necessarily raising the air temperature in the vivarium or tank. The choice of heat mat size and installation method will depend very much on the requirements of the species and the design and size of the set up and supplementary heating may be required for species that require a more intense heat or localised basking spots to raise their body temperature sufficiently. Care must be taken to comply with the safety and installation instructions and the use of a thermostat is essential.

Resin jelly pot holder for two jelly pots in a wood finish. Measures 11 x 9 x 2.5 cm deep.

ProRep Infrared Lamps

ProRep Infrared Lamps have been developed specifically for use with reptiles. Made with a specially sourced red glass to filter out as much of the visible light spectrum as possible these lamps have been developed for reptiles that do not require much visible light such as crepuscular species. ProRep Infrared Lamps provide heat in the form of infrared to warm enclosures during periods that do not require much visible light.

Select the appropriate lamp for the set up you are trying to create and ensure the wattage is correct for the animal, enclosure size and construction. Use in the approved fitting of the correct type. Mount the lamp directly above the basking site approximately one third from the end of the tank to create a temperature gradient allowing natural thermo-regulatory behaviour. The use of a dimming thermostat is highly recommended to prevent overheating. This product must be used with an appropriate lamp guard to ensure the animal does not come into contact with the lamp which will result in the animal getting burnt.

These have a great natural look to them and would look good in any Terrarium or Vivarium.

• Non Tip
• Attractive natural finish
• Great value

Air plant supplied in mesh pocket with header card. Airplants need to be kept at a temperature of above 8 degrees Centigrade, in a draft free environment.

They can be dunked into rain water once a week, and then shaken gently to remove residual water and fed with a propritary air plant fertilizer. they proivide long lasting natural decor for vivariums and terrariums and can be attached to vines, stones, trunks, in fact almost anything for a naturalistic finish.

Air plant supplied in mesh pocket with header card. Airplants need to be kept at a temperature of above 8 degrees Centigrade, in a draft free environment. They can be dunked into rain water once a week, and then shaken gently to remove residual water.

ProRep Heat Mats and Heat Strips are designed for use with reptiles, amphibians and invertebrates. They work by producing ultra-long wavelength infra-red heat that is absorbed by the animal and cage furnishings in much the same way as the sun warms basking animals or the ground in the wild.

This action allows the animals to warm themselves without necessarily raising the air temperature in the vivarium or tank. The choice of heat mat size and installation method will depend very much on the requirements of the species and the design and size of the set up and supplementary heating may be required for species that require a more intense heat or localised basking spots to raise their body temperature sufficiently.

Care must be taken to comply with the safety and installation instructions and the use of a thermostat is essential. ProRep Heat Mats and Strips are available only in cloth heating element materials - and in a range of sizes to suit most heating requirements and are manufactured in the UK to the highest safety standards.

The Sticky Back models are design to be fixed to the wall or ceiling of an enclosure through the use of the special adhesive which is applied to the heat mat.

ProRep Bug Grub is a complete dry diet, high in calcium and protein, designed for the breeding and maintenance of all livefood insects.

It is made from the highest quality ingredients to ensure maximum palatability.

Directions: Place Bug Grub in a shallow dish and place in the feeder insects enclosure, ensuring that the insects can get to it. Only feed enough Bug Grub each time to last 1 or 2 day. Provide fresh food regularly as mould will grow if Bug Grub gets wet. Bug Gel and/or small pieces of Carrot should always be provided as a source of moisture.

Precautions: Not for human consumption. Wash hands after use. Do not inhale dust.

Contents: Protein 16%, Oil B 4.5%, Fibre 17.2%, Ash 11%, Moisture 13.8%, Magnesium 0.3%, Vitamin A 5000iu/kg, Vitamin D3 500iu/kg, Vitamin E 20iu/kg, Selenium 0.05mg/kg, Copper 30mg/kg.

Cork bark is a great natural looking addition to your vivarium. The flat pieces can be built up to make ledges or climbing places for your reptiles.

Hide made from natural wood that fits into any design of vivarium or terrarium.

Bug Balls are the ideal way to provide water to feeder insects without the risk of them drowning. They are available in 500g resealable packs in a variety of different colours. Simply place a suitable number of balls in a shallow container in the livefood holding tank to prolong the life of the insects and keep them healthy. Replace as needed and re-seal the pack to retain freshness.

ProRep Heat Mats and Heat Strips are designed for use with reptiles, amphibians and invertebrates. They work by producing ultra long wavelength infra red heat that is absorbed by the animal and cage furnishings in much the same way as the sun warms basking animals or the ground in the wild.

This action allows the animals to warm themselves without necessarily raising the air temperature in the vivarium or tank. The choice of heat mat size and installation method will depend very much on the requirements of the species and the design and size of the set up and supplementary heating may be required for species that require a more intense heat or localised basking spots to raise their body temperature sufficiently.

Care must be taken to comply with the safety and installation instructions and the use of a thermostat is essential. ProRep Heat Mats and Strips are available only in cloth heating element materials - and in a range of sizes to suit most heating requirements and are manufactured in the UK to the highest safety standards.

The High Out Put models are design to be fixed to the wall or ceiling of an enclosure through the use of the special adhesive which is applied to the heat mat. These heat mats produce a much higher temperature than standard heat mat models, they MUST be used with a thermostat and they MUST not be covered.

Plastic Bayonet to Screw Converter (BC to ES, for ES Bulbs). Now you can enjoy the freedom of using screw bulbs in your bayonet light fittings. Tough plastic adapters - fully insulated and conforming to BS safety standards. Quick to change. Easy to use.

Heater Guards for spot lamps or small ceramic heaters to protect animals from burning themselves. Simple, lightweight but strong powder coated steel design that allows maximum light penetration. Unique hinged panel with double security fasteners that allows easy access to lamps without the need to remove the fixture. These guards have four mounting brackets and cut-out for cable entry to enable flush mounting to the roof of wooden vivaria.

L 12cm W 12cm H 17cm

Air plant supplied in mesh pocket with header card. Airplants need to be kept at a temperature of above 8 degrees Centigrade, in a draft free environment.

They can be dunked into rain water once a week, and then shaken gently to remove residual water and fed with a propritary air plant fertilizer. they proivide long lasting natural decor for vivariums and terrariums and can be attached to vines, stones, trunks, in fact almost anything for a naturalistic finish.

ProRep Heat Mats and Heat Strips are designed for use with reptiles, amphibians and invertebrates. They work by producing ultra long wavelength infra red heat that is absorbed by the animal and cage furnishings in much the same way as the sun warms basking animals or the ground in the wild. This action allows the animals to warm themselves without necessarily raising the air temperature in the vivarium or tank. The choice of heat mat size and installation method will depend very much on the requirements of the species and the design and size of the set up and supplementary heating may be required for species that require a more intense heat or localised basking spots to raise their body temperature sufficiently. Care must be taken to comply with the safety and installation instructions and the use of a thermostat is essential.