ProRep Coco Bedding Coarse 10 litre

This product is covered by our Safe Delivery Guarantee

RRP £9.99 Save £1.80
RRP €11.44 Save €2.06
RRP $14.14 Save $2.55
RRP $18.31 Save $3.30
RRP DKK85.18 Save DKK15.35
RRP NOK109.51 Save NOK19.73
RRP SEK116.60 Save SEK21.01
RRP $18.20 Save $3.28
You save £1.80
You save €2.06
You save $2.55
You save $3.30
You save DKK15.35
You save NOK19.73
You save SEK21.01
You save $3.28

ProRep Coco Bedding Coarse 10 litre

Product Code: SPC610

ProRep Coco Bedding Coarse 10 litre

More product images

ProRep Coco Bedding Coarse 10 litre

Printer Friendly

Download the Buying Guide

Download the Technical Guide

ProRep product description banner

ProRep A moisture retaining substrate suitable for many species of reptile, amphibian and invertebrate.

A 100% natural versatile bedding made from the fibrous husk of the coconut, all species of amphibians, reptiles and invertebrates that require a humid environment will thrive on this safe and sustainable substrate.

Once removed from the coconut the fibrous husk is screened and then prepared for use by grinding to the appropriate size. This slightly acidic substrate contains high antibacterial properties and has a high percentage of lignin which will resist rotting, even under wet conditions.

Directions: Spread the substrate evenly over the bottom of the enclosure to a depth of 1-2? (2.5-5cm). Spot clean daily by removing soiled areas of substrate and replacing with fresh Coco Bedding. Coco Bedding can be used either on its own or as a mix with other substrates and can be used wet or dry. If extra humidity is required then moisten the Coco Bedding but avoid over wetting and making it waterlogged. As the Coco Bedding dries out it can be sprayed to maintain the required moisture level. The Coco Bedding should be replaced every two to three weeks or more frequently if it becomes heavily soiled.

When using with a heat mat: If you are using a heat mat under a substrate or glass tank the substrate depth must be NO greater than 1cm and the thermostat sensor should be positioned on the mat. Always refer to the heat mat manufacturer?s instructions for instruction of use, failure to do so may result in the heat mat overheating.